Smart Switch BC 8000 Bilge Controller

The BC-8000 Controller provides an intelligent networked solution for the monitoring and control of up to eight bilge areas. The diagram (right) shows a typical system layout. The system consists of the BC-8000 display controller (as seen above) up to eight BC-100 or BC-100/P controllers and one (optional) RB-800 repeater displays. The system communicates via a 2-wire network cable with a maximum cable length of 1000 meters.

BC- 8000 Display Controller: Is a powerful bilge control system.

• Full control from one central location on your boat.
• Delay pump on and off time (programmable).
• Pump on alarm time (programmable).
• Visual status display for each bilge area showing pump status, low sensor status, last pump run time, number of pump runs, program & operate modes.
• Turn bilge pumps on/off manually or automatically
• Visual & audible alarm for any fault conditions e.g. high water, low sensor fault, pump fault, time alarm.
• Two master modes of operation automatic or semi-automatic.
• Individual modes auto or manual.
• All bilge areas are name programmable giving location e.g. (Aft Port) (Engine Room) (Mid Ship Starboard).

• Automatically goes into stand alone mode if communication with the BC-8000 is lost giving normal operation if either the hi or low sensors turn on.
• Controls the pump and provides the input for the hi & low sensors.
• Pump output = 88 amps @ 12 vdc.
• Operates with any standard float switch or Smart switch FS-2A.
• Alarm relay = 3 amp inductive.
• Supplied in two different models:
• HT-100/P features hi & low sensors, alarm relay, and pump output
• HT-100 features hi & low sensors and alarm relay

Retail Price: AUD $1,530.00

Price: AUD $1,453.00